mitutoyo lsm-9506 Benutzerhandbuch

1. Safety Precautions

The Mitutoyo Laser Scan Micrometer LSM-9506 uses a laser beam.

1) “This LSM conforms to the US CDRH regulations in 21 CFR 1040 for a class 

II

laser product.”

2) Do not look directly into the laser beam.  (Never look into the  emission window,

even when no light is emitted.)

3) Do not observe the laser beam directly through optical equipment, such as a

magnifying lens.

4) When measuring flat objects with mirror finishes, avoid looking at the reflection on

the surface.

5) Close the beam shutter when not in use.

6) Do not open the emission unit cover except for servicing.  The output power

when the cover is open is about 1.2mW.

7) Do not remove the “CAUTION” or “WARNING” labels.

8) The laser beam does not harm human skin when irradiating.

9) “CAUTION – Use of controls or adjustments or performance of procedures other

than those specified herein may result in hazardous radiation exposure.”

CAUTION

LASER LIGHT-DO NOT

STARE INTO BEAM

1mW-650nm

CLASS

II

 LASER PRODUCT

2. If an optional device is to be connected to this system, make sure that the optional device is

also turned off.

3. Firmly tighten the screws of the cable connectors and interfaces to ensure shielding.

4. Do not touch the terminals of the connectors, otherwise contact may be poor.

5. Positively ground the Display Unit.

6. An error display may appear during operation. However, it may not always indicate a fault. If

an error display appears, consult the “Maintenance and Inspection” section.

Do not open the covers provided on the emission unit and reception unit.