Lennox gas stove Benutzerhandbuch

This stove requires a balanced flue to ensure proper com-

bustion. As such, flue restrictors may need to be installed

depending  on  the  vent  configuration  of  your  stove.  The

drawings  on  the  following  page  show  all  the  allowable

pipe configurations for the Vision™ gas stove. To properly

install the flue restrictor, find your pipe configuration in the

drawings on the following page and note which restrictor

setting is recommended. The flue restrictor is shipped in

the firebox of your stove. To install the restrictor, see Figure

18. Remove the two 5/32” allen head screws (A below).

Using pliers, repeatedly bend the unwanted portion of the

flue restrictor and discard. Install the flue restrictor using

the two 5/32” allen head screws according to the diagram

below. Install the flue restrictor screws in their original holes

in the top of the firebox. Restrictor positions are based on

tests run in a laboratory.

1. All vertically terminated vent installations use 6-5/8”x 4”

Security™ Secure Vent™ pipe*.

2. If the vent passes through a ceiling or floor, a firestop

- Simpson #963 or Security #SV4BF - is required.

3. If  the  vent  passes  through  the  roof,  a  roof  flashing  -

Simpson #943 or 943S or Security #SV4FA or SV4FB

- and storm collar - Simpson #953 or Security #SV4FC

- are required.

4. A  1-inch  clearance  from  the  vent  pipe  to  combustible

materials must be maintained.

5. A maximum of either two 45º elbows or two 90º elbows

may be used. See page 14 for allowable offsets.

6. The maximum system height is 30 feet and the minimum

is 10 feet.