Cub Cadet 933 SWE Benutzerhandbuch

The auger control is located on the left handle. Squeeze the 

control grip against the handle to engage the augers and start 

snow throwing action. Release to stop.

The drive control is located on the right handle. Squeeze the 

control grip against the handle to engage the wheel drive. 

Release the handle to stop. 
The drive control also locks the auger control so that you can 

operate the chute directional control without interrupting 

the snow throwing process. If the auger control is engaged 

simultaneously with the drive control, the operator can release 

the auger control (on the left handle) and the augers will remain 

engaged. Release both controls to stop the augers and wheel 

drive. 
NOTE: Always release the drive control before changing speeds. 

Failure to do so will result in increased wear on your machine’s 

drive system.

The two-way chute-pitch control is located on the left side of the 

dash panel and is used to control the distance of snow discharge 

from the chute.
• 

To change the upper chute angle to control the distance 

that snow is thrown, pivot the lever forward or backward. 

• 

Move the lever forward to pivot the upper chute down and 

reduce the distance snow is thrown.

• 

Move the lever rearward to pivot the upper chute upward 

and increase the distance snow is thrown.

• 

NOTE: To increase or decrease the tension on the two-way chute 

control, tighten or loosen the wing knob on the chute assembly 

as shown in Fig. 4-2.  

The chute directional control is located on the left side of the 

snow thrower.
• 

To change the direction in which snow is thrown, crank 

clockwise to discharge to the left and counterclockwise to 

discharge to the right.

CHUTE DIRECTIONAL CONTROL

DISCHARGE

LEFT

DISCHARGE

RIGHT

CHUTE TILT

DOWN

CHUTE TILT

UP