ICOM ic-m801gmdss Benutzerhandbuch
■ Functions for receive (continued)
D
D Clarity control
Voice signals received from other stations may be diffi-
cult to receive. This may sometimes happen if a sta-
tion is transmitting slightly off frequency. In such cases,
you can compensate by using the clarity control.
cult to receive. This may sometimes happen if a sta-
tion is transmitting slightly off frequency. In such cases,
you can compensate by using the clarity control.
q Push [F] then [RX
CLAR
] to switch the function ON
and OFF.
• “CLAR” and shifting value with direction appear.
w Rotate [CH] to improve the audio readability.
• Adjustable between ±150 Hz in 10 Hz steps.
[RX
CLAR
]
[CH]
[F]
12
4
RECEIVE AND TRANSMIT
■ FSK operation
The transceiver has AFSK operation capability when
an AFSK terminal unit is connected— use J2B for
AFSK operation.
an AFSK terminal unit is connected— use J2B for
AFSK operation.
q Connect an AFSK terminal unit to the [AF/MOD]
socket as shown at right.
w Select the desired channel to operate AFSK mode.
e Push [MODE
e Push [MODE
SET
] several times to select J2B.
r Operate the AFSK terminal unit.
NOTE:
Some transceivers may operate 1.7 kHz higher
than the IC-M801GMDSS’s J2B mode even when
the same displayed frequencies are in use.
Some transceivers may operate 1.7 kHz higher
than the IC-M801GMDSS’s J2B mode even when
the same displayed frequencies are in use.
AFSK terminal unit connection
1
5
11
15
To pins 1, 2
To pin 9
To pin 5
MOD output
MOD ground
AF input
AFSK terminal unit
AF ground
Tx/Rx control
Ground
To pins 3, 4
D
D Tuner through function
In the combination with IC-M801GMDSS and optional
AT-141, the tuner through function can be used.
AT-141, the tuner through function can be used.
By bypassing the tuner unit, the receiver gain in par-
ticular frequency band may be improved depending
on your antenna element length.
ticular frequency band may be improved depending
on your antenna element length.
➥While “TUNE” is displayed, push [F] then
[TUNE
THRU
] to tuner through function ON.
• “THRU” appears instead of “TUNE” indicator.
• Push [TUNE
• Push [TUNE
THRU
] to turn the function OFF.
[TUNE
THRU
] [F]