OKI fax 5050 Benutzerhandbuch
Customizing
53
18 MEM./FEEDER
SW.:
This function controls how
OKIFAX normally transmits fax messages: by scanning
the document into memory first, or by transmitting di-
rectly from the document feeder. Available settings are
FEEDER (default) and MEMORY.
the document into memory first, or by transmitting di-
rectly from the document feeder. Available settings are
FEEDER (default) and MEMORY.
Note:
If you are using the MEMORY setting and you send
a large number of faxes in one session, you may
encounter a MEM OVERFLOW error message. If this
occurs often, you can correct the problem either by
adding an optional memory upgrade or by changing to
the FEEDER setting.
encounter a MEM OVERFLOW error message. If this
occurs often, you can correct the problem either by
adding an optional memory upgrade or by changing to
the FEEDER setting.
2 0
ECM FUNCTION:
The error correction mode function
may help your OKIFAX improve communication in areas
where telephone line conditions are marginal. See the
Troubleshooting section of this Handbook for other sug-
gestions if you have communication problems. Available
settings are ON (default) and OFF.
where telephone line conditions are marginal. See the
Troubleshooting section of this Handbook for other sug-
gestions if you have communication problems. Available
settings are ON (default) and OFF.
2 1
REMOTE DIAGNOSIS:
The remote diagnostics feature al-
lows a service person remotely to dial and service your
OKIFAX. Available settings are ON and OFF (de-
fault).
OKIFAX. Available settings are ON and OFF (de-
fault).
22
Not used.
23
ONE TOUCH PARAM:
This function allows you to acti-
vate the Echo Protection feature for a specific One
Touch key, without changing the normal settings.
Echo Protection can improve communication with a
Touch key, without changing the normal settings.
Echo Protection can improve communication with a
location in a noisy telephone area. For instructions
on changing One Touch Parameters settings for a
One Touch key, see page 28.
on changing One Touch Parameters settings for a
One Touch key, see page 28.
Changing Your User Function Settings
1
Press the Select Function key.
2
Press the 9/User Program One Touch key.
The display shows 1:FUNC. PROGRAMMING.
The display shows 1:FUNC. PROGRAMMING.
3
Press the Yes
§ key. The display shows FUNCTION
NO. [ ].
4
Using the numeric keypad, enter the 2-digit number of
the function you want to change. The display shows the
name of the selected function.
the function you want to change. The display shows the
name of the selected function.
5
Repeatedly press the No
©
key until the setting you want
appears in the display.
Note:
If you are changing the TX MODE DEFAULT set-
tings, the new settings appear on the lights above the
Yes
Yes
§ and the No © keys
6
Press the Yes
§ key to confirm your selection. The
name of the next function setting appears in the
display.
display.
7
Press the Select Function key to finish.
Of5050hw.pm6
4/15/98, 9:32 AM
53