Juniper Networks T1600 Benutzerhandbuch
■
You can install any transceiver supported by the PIC. For information about installing
and removing transceivers, see the PIC and Transceiver Installation Instructions.
and removing transceivers, see the PIC and Transceiver Installation Instructions.
■
Fiber-optic SFP transceivers:
■
Duplex LC/PC connector (Rx and Tx)
■
Optical interface support—see Table 21 on page 48
■
1000Base-T SFP transceivers:
■
Connector: Four-pair, Category 5 shielded twisted-pair connectivity through an RJ-45
connector
connector
■
Pinout: MDI crossover
■
Length: 328 ft/100 m
NOTE: Do not install SONET/SDH OC48c/STM16 SFPs in the Gigabit Ethernet port. The port
will not recognize the SFP.
will not recognize the SFP.
Cables and connectors
Status LED, one tricolor:
■
Off—Not enabled
■
Green—Online with no alarms or failures
■
Amber—Online with alarms for remote failures
■
Red—Active with a local alarm; router has detected a failure
NOTE: The green status LED is lit on the 2-port Gigabit Ethernet IQ PIC when at least one
port is online.
port is online.
Port LEDs, one per port:
■
Off—Port is down
■
Green—Link is established
LEDs
Table 21: Optical Interface Support for Gigabit Ethernet IQ PICs with SFP
1000Base-LH
1000Base-LX
1000Base-SX
Parameter
Single-mode
Single-mode
Multimode
Optical interface
SFP
SFP
SFP
Transceiver type
Multivendor
agreement
agreement
IEEE 802.3—1998
IEEE 802.3—1998
Standard
9/125 SMF cable:
43.5 miles/70 km
43.5 miles/70 km
9/125 SMF cable:
6.2 miles/10 km
6.2 miles/10 km
62.5/125 or 50/125
MMF cable:
1804.5 ft/550 m
MMF cable:
1804.5 ft/550 m
62.5/125 MMF cable:
656 ft/200 m
656 ft/200 m
50/125 MMF cable:
1640 ft/500 m
1640 ft/500 m
Maximum distance
1480 through 1580
nm
nm
1270 through 1355
nm
nm
770 through 860 nm
Transmitter
wavelength
wavelength
–3 through +3 dBm
–11.5 through –3
dBm
dBm
–9.5 through 0 dBm
Average launch power
48
■
Gigabit Ethernet IQ PICs with SFP
T1600 Internet Routing Node PIC Guide