Juniper Networks T1600 Benutzerhandbuch
■
Quality of service (QoS) per channel: weighted round-robin (WRR), random early detection
(RED), weighted random early detection (WRED)
(RED), weighted random early detection (WRED)
■
Configurable WAN-PHY mode options:
■
loopback
■
mpls
■
path-trace
■
trigger
■
Flexible Ethernet Services Encapsulation
■
802.1q virtual LANs (VLANs)
■
Ethernet OAM 802.1ag continuity check
■
Ethernet OAM 802.3ah (remote loopback is not supported for this PIC)
■
VLAN stacking
■
Channels defined by two stacked VLAN tags
■
Multiple tag protocol identifiers (TPID) support
■
IP service for nonstandard TPID and stacked VLAN tags
■
MAC learning, accounting, and filtering
■
Virtual Router Redundancy Protocol (VRRP) support
Software features
■
You can install any transceiver supported by the PIC. For information about installing
and removing transceivers, see the PIC and Transceiver Installation Instructions.
and removing transceivers, see the PIC and Transceiver Installation Instructions.
■
Fiber-optic 10-gigabit small form-factor pluggable (XFP) transceivers:
■
Connector: Duplex LC/PC (Rx and Tx)
■
Optical interface support—See Table 28 on page 64
Cables and connectors
Port LED, one for each port:
■
Off—Port is not enabled
■
Green—Port is online with no alarms or failures
■
Amber—Port is online with alarms for remote failures
■
Red—The router has detected a failure with alarms for local failures
LEDs
10-Gigabit Ethernet LAN/WAN PIC with XFP
■
63
10-Gigabit Ethernet LAN/WAN PIC with XFP