Hoyt compound-2002 Benutzerhandbuch

17

inner-cam is in the desired location, reinstall and
tighten the Draw Length screw first and then the
Fastening Screw.  Each position will provide approxi-
mately 1/2” longer/shorter draw than the previous
setting Note:  You must make the same adjustments to
the top and the bottom inner-cams or the bow cannot
be properly tuned. 

OPTIMIZING COMMAND CAM PERFORMANCE
In order to verify optimum performance of your
Command Cam bow you should examine the cam's
built in alignment marks. When viewing the module
side of the cam your bus cable should lie somewhere
between the
a l i g n m e n t
marks as shown.
It is not neces-
sary to have the
buss cable 
exactly centered
between the
marks. In fact,
the optimum
position may be
at either extreme
side of the timing marks for your particular combi-
nation. Exact cam alignment varies slightly with dif-
ferent limb and riser combinations. Your bow was
shipped new in the optimum postion. If your buss
cable lies outside the alignement marks we recom-
mend you take it to your nearest Hoyt dealer for
adjustments.