Uniden exp 4241 Benutzerhandbuch
6
Find Handset
To locate the handset, press the find hs key on the base. The handset beeps for 60 seconds.
The handset stops beeping when any key is pressed, when it is returned to the base, or when
the find hs key is pressed. The handset also stops beeping when an incoming call is received.
Low Battery Alert
When the battery pack is very low and needs to be charged, the phone is programmed to
eliminate functions in order to save power. If the phone is not in use, the talk/batt low LED
flashes when the battery pack is low.
If the phone is in use, the talk/batt low LED flashes and the handset beeps. Complete your
If the phone is in use, the talk/batt low LED flashes and the handset beeps. Complete your
conversation as quickly as possible and return the handset to the base for charging.
NOTE: • Even when the battery pack is not being used, it will gradually discharge over a long
period of time. For optimum performance, be sure to return the handset to the base
unit after each telephone call.
• Dial mode setting, last number dialed and numbers stored in memory locations
are retained for up to one minute while you replace the battery pack.
Cleaning the battery charging contacts
To maintain a good charge, clean the charging contacts on the
handset once a month.
Dampen a cloth with plain water. Gently rub the damp cloth over
Dampen a cloth with plain water. Gently rub the damp cloth over
the charging contacts until all visible dirt is removed. Dry the
contacts thoroughly before returning the handset to the base.
Caution: Do not use paint thinner, benzene, alcohol, or other
Caution: Do not use paint thinner, benzene, alcohol, or other
chemical products. Doing so may discolor the surface of the
telephone and damage the finish.
Tone Dialing Switch-over
If your telephone company requires pulse dialing, you can switch over
to tone dialing after the call connects. This feature is useful when you
need tone dialing to use any automated menu systems, such as
telephone bank tellers, telephone prescription refills, customer support
menus, etc.
If your phone is set to pulse dialing mode, make your call normally.
If your phone is set to pulse dialing mode, make your call normally.
Once your call connects, press the
*
/tone key. Any digits you enter
from then on will be sent as tone digits. When this particular call ends,
the phone automatically returns to pulse dialing mode.
Using the Speed Dial Memory
Storing Numbers in Speed Dial Memory
Your cordless phone can store up to ten numbers in the speed dial memory.
1) When the phone is in standby mode, press the memory key. The talk/batt low LED flashes.
2) Use the keypad to enter the phone number; each number can be up to 20 digits.
1) When the phone is in standby mode, press the memory key. The talk/batt low LED flashes.
2) Use the keypad to enter the phone number; each number can be up to 20 digits.
up077.fm Page 6 Thursday, December 14, 2006 2:31 PM