Hoshizaki f043-809 kmd-410mwh Benutzerhandbuch
20
6. BIN CONTROL
This machine uses a lever-actuated proximity switch (mechanical bin control) to control the
ice level in the storage bin. No adjustment is required.
[a] EXPLANATION OF OPERATION
ice level in the storage bin. No adjustment is required.
[a] EXPLANATION OF OPERATION
The bin control is connected to the K1 connector (pins 4 & 5) on the control board.
When the bin control is calling for ice (proximity switch closed; "POWER OK" LED on), the
control board continues icemaking operations. When the bin control is activated in the bin
full position (proximity switch open; "POWER OK" LED flashing), the control board drains
and shuts down the unit. However, to prevent incomplete batches of ice from forming on the
evaporator, the control board will only shut down the machine during the freeze cycle before
the five minute timer expires. The five minute timer starts counting down when the
thermistor temperature reaches 2°C. If, during the freeze cycle, ice pushes in the lever after
the five minute timer expires, the control board will allow the machine to complete the freeze
cycle and the following harvest cycle before shutting down the machine.
[b] BIN CONTROL CHECK PROCEDURE
When the bin control is calling for ice (proximity switch closed; "POWER OK" LED on), the
control board continues icemaking operations. When the bin control is activated in the bin
full position (proximity switch open; "POWER OK" LED flashing), the control board drains
and shuts down the unit. However, to prevent incomplete batches of ice from forming on the
evaporator, the control board will only shut down the machine during the freeze cycle before
the five minute timer expires. The five minute timer starts counting down when the
thermistor temperature reaches 2°C. If, during the freeze cycle, ice pushes in the lever after
the five minute timer expires, the control board will allow the machine to complete the freeze
cycle and the following harvest cycle before shutting down the machine.
[b] BIN CONTROL CHECK PROCEDURE
1) Clear any ice away from the bin control.
2) Make sure the control switch is in the "ICE" position.
3) Check that the "POWER OK" LED on the control board is on.
4) Activate the bin control actuator (press the actuator in). Check that the "POWER OK" LED
2) Make sure the control switch is in the "ICE" position.
3) Check that the "POWER OK" LED on the control board is on.
4) Activate the bin control actuator (press the actuator in). Check that the "POWER OK" LED
flashes.
5) Disconnect the bin control at the 2-pin connector attached to the black wires coming from
the K1 connector (pins 4 & 5) on the control board.
6) Check for continuity across the bin control leads. When calling for ice, the bin control
proximity switch should be closed. If open, replace the bin control. Activate the bin control
actuator (press the actuator in), check for continuity across the bin control leads. The bin
control proximity switch should be open. If closed, replace the bin control.
actuator (press the actuator in), check for continuity across the bin control leads. The bin
control proximity switch should be open. If closed, replace the bin control.
7) Reconnect the 2-pin connector. Allow the machine to cycle into the freeze cycle. In the
first 5 minutes of the freeze cycle, activate the bin control actuator (press the actuator in).
The "POWER OK" LED should flash and the machine should turn off. If not, replace the
control board.
The "POWER OK" LED should flash and the machine should turn off. If not, replace the
control board.