Hoshizaki f043-809 kmd-410mwh Benutzerhandbuch

21 

Two different control switches are used for operation of KMD-410MAH and KMD-410MWH. 
These switches are referred to as the "control switch" and the "service switch" and are 
located on the control box. 
 
[a] CONTROL SWITCH 

This switch is used to place the machine into one of three modes: “OFF” (center position), 
“ICE” (upper position), and “SERVICE” (lower position). 
 
[b] SERVICE SWITCH 

When the control switch is in the “SERVICE” position, the control switch supplies power to 
the service switch and the machine is in service mode. The service switch has three 
positions: “DRAIN,” “CIRCULATE,” and “WASH.” See the information below for details of 
each function. 
 Note: 

1. When the service switch is activated, power is supplied to the water pump in all three 

positions. 

2. When the control switch is in the “OFF” position or in the “ICE” position, the service 

switch has no power and can be left in any position. 

 
1) DRAIN 

The KMD-410M_H series utilizes a pump-out drain system. When the service switch is 
active and placed in the “DRAIN” position, power is supplied to the pump and drain valve. 
 
2) CIRCULATE 

When the service switch is active and placed in the “CIRCULATE” position, power is 
supplied to the pump only. This operation can be used to circulate cleaner for extended 
periods of time over the outside surface of the evaporator.

 

 
3) WASH 

 

The KMD-410M_H series utilizes a solenoid operated wash (bypass) valve. When the 
service switch is active and placed in the “WASH” position, power is supplied to the pump 
and wash valve. This operation is used to circulate cleaner and sanitizer over both the inside 
and outside of the evaporator.