bobcat 2200d Benutzerhandbuch
Bobcat 2200 Diesel Vehicle
Operation & Maintenance Manual
Operation & Maintenance Manual
10
CAUTION
•
Be careful not to damage the safety belt webbing
or hardware.
or hardware.
•
Inspect the safety belt system periodically. Check
for cuts, fraying, and loose parts. Damaged parts
should be replaced immediately. Do not
disassemble or modify the system.
for cuts, fraying, and loose parts. Damaged parts
should be replaced immediately. Do not
disassemble or modify the system.
•
Keep safety belts clean and dry. If cleaning is
necessary, use a mild soap and lukewarm water
solution. Do not use bleach, dye or abrasive
cleaners as they may severely weaken the safety
belts.
necessary, use a mild soap and lukewarm water
solution. Do not use bleach, dye or abrasive
cleaners as they may severely weaken the safety
belts.
•
Do not insert coins, clip, etc. in the buckle as this
may prevent the tab from locking into the buckle
properly.
may prevent the tab from locking into the buckle
properly.
•
If the safety belt does not function normally,
contact your Bobcat dealer or trained technician
immediately. Do not occupy the seat until the
safety belt is repaired.
contact your Bobcat dealer or trained technician
immediately. Do not occupy the seat until the
safety belt is repaired.
Figure 6
Secure Safety Belt
Figure 7
Release Safety Belt
SEAT LATCH AND ADJUSTMENT
The seats are hinged to allow easy access to the engine
compartment. A latch at the rear of each seat bottom
keeps the seat from moving on its hinges while the
vehicle is in operation. To disengage the latch, grasp the
seat back and pull firmly in a forward/upward direction
until the latch releases. To engage the seat latch, push
down firmly on the seat back until the seat locks into
place. See following WARNING.
compartment. A latch at the rear of each seat bottom
keeps the seat from moving on its hinges while the
vehicle is in operation. To disengage the latch, grasp the
seat back and pull firmly in a forward/upward direction
until the latch releases. To engage the seat latch, push
down firmly on the seat back until the seat locks into
place. See following WARNING.
WARNING
•
Make sure seat hinges and latch are securely
engaged before operating vehicle.
engaged before operating vehicle.
The driver-side bucket seat is adjustable and can be
moved forward or backward to accommodate the driver.
To adjust seat, push lever located under the driver seat to
the left (towards outside of the vehicle). Position seat and
return lever to its original position. See following
WARNING.
moved forward or backward to accommodate the driver.
To adjust seat, push lever located under the driver seat to
the left (towards outside of the vehicle). Position seat and
return lever to its original position. See following
WARNING.
WARNING
•
Do not adjust driver-side seat while vehicle is in
motion.
motion.
To adjust the passenger-side seat:
1. Remove the seat from the vehicle.
2. Remove the four bolts and washers from the bottom
of the seat mounting plate.
3. Align the mounting plate holes with holes in the seat
to achieve the desired seat position.
4. Install washers and bolts and tighten to 10,8 Nm.
5. Install seat in the vehicle. See preceding WARNING
“Make sure seat hinges and latch...”.
1