bobcat 2200d Benutzerhandbuch
Bobcat 2200 Diesel Vehicle
Operation & Maintenance Manual
Operation & Maintenance Manual
28
BRAKE FLUID RESERVOIR
Figure 14 Brake Fluid and Coolant Access Door
Figure 15 Brake Fluid Reservoir
The brake fluid reservoir (1) is located under the
dashboard [Figure 14]. Raise the access panel located
on top of the dashboard to check the brake fluid level.
dashboard [Figure 14]. Raise the access panel located
on top of the dashboard to check the brake fluid level.
When checking the brake fluid, also inspect the following:
•
The presence of brake fluid on the exterior surface of
the master cylinder indicates a leak.
the master cylinder indicates a leak.
•
The brake fluid reservoir diaphragm (located in the
cap) should not have holes or other damage.
cap) should not have holes or other damage.
Brake Fluid
Brake fluid level should be within 6 mm from the top of
the reservoir [Figure 15]. Also, brake fluid should be
clean with no residue in the bottom of the reservoir or
other evidence of contamination.
the reservoir [Figure 15]. Also, brake fluid should be
clean with no residue in the bottom of the reservoir or
other evidence of contamination.
CAUTION
•
Use only DOT 5 (silicone) brake fluid. Use of any
other type brake fluid is not recommended.
other type brake fluid is not recommended.
ENGINE OIL
Even though the low oil warning light on the instrument
panel should illuminate if the oil level becomes low, the
engine oil level should be checked daily. The vehicle
should be on a level surface when the oil is checked. Do
not overfill with oil.
panel should illuminate if the oil level becomes low, the
engine oil level should be checked daily. The vehicle
should be on a level surface when the oil is checked. Do
not overfill with oil.
Engine Oil Level Check
1. Remove the oil level dipstick from the oil filler tube
and wipe oil from the dipstick [Figure 16]. See
following CAUTION.
following CAUTION.
CAUTION
•
Do not remove dipstick while engine is running.
2. Check oil level by fully inserting the dipstick into the
tube and immediately removing it.
3. If the oil level is at or below the low level mark on the
dipstick gauge, add oil until the level is between low
and full levels (safe level).
and full levels (safe level).
CAUTION
CAUTION
•
Do not fill oil above the full level mark. Doing so
will result in decreased engine performance or
damage to the engine.
will result in decreased engine performance or
damage to the engine.
Figure 16 Engine Oil Level Check
1
2
WA
R
NING
USE ONL
Y
DOT 3 FL
UID
FROM A
SEALED
CON
TAI
NER
MAX
MIN
USE ONLY
D
. O
.
T
.
3
F
L
U
ID
F
R O
M
A
S E
AL
E D
C
O
N
T
A
IN
E
R
CLEAN F
IL
L
E
R
C
A
P
S
BE
FO
R E
R
E M
O
V
I
N
G
MIN
MAX
Ful l
Lev el
Low
Lev el
Safe Le vel
Full
Low
Level
Safe
Level
Level
1
2
3