Dacor DR30DH-C Benutzerhandbuch

Planning the Installation

Self-Rimming Installation With 

Raised Vent

•

Only model DR30DI may be installed with a raised vent. Use 

only Dacor raised vent model ERV3015.

•

A self-rimming countertop configuration is required for raised 

vent installation. On installations with a raised vent, when 

sliding the range into position, it will stop when the rear of the 

control panel or side panels contact the notches toward the 

front of the countertop.

•

The self-rimming installation of the DR30DI range and 

ERV3015 raised vent create a “built-in” look where the range 

trim overlaps the countertop on both sides and the raised 

vent overlaps the countertop in back. It is also possible, if the 

cabinets are deep enough, to self rim the front of the range 

into the cabinet face immediately behind the control panel 

and door trim or behind the side panels (see side views on 

this and the facing page). The rear range trim will partially 

cover the front of the raised vent chassis in back.

Countertop self-

rimmed only

20 5/8”  

(52.4 cm)

0” (0 cm) to 

3 1/4” 

(8.3 cm)

0” (0 cm) to 

5 3/8” (13.7 cm)

Countertop and 

Cabinet Front 

Self-Rimmed

,

20 5/8” *  

(52.4 cm)

NA

0” (0 cm) to 

5 3/8” (13.7 cm)

Countertop and 

Cabinet Front 

Self-Rimmed (side 

panels removed)

23 7/8” * 

(60.6 cm)

NA

0” (0 cm) to 

2 1/8” (5.4 cm)

* Cabinet face below countertop must be flush with back of notch 

in countertop.
Countertop height for all self-rimming installations:  

35 7/16” (90.0 cm) minimum, 37 7/16” (95.1 cm) maximum
IMPORTANT: If the 3 1/4 inch side panels are removed, the 

cabinet face must be flush with the back of the control panel.

rear wall recommended

Non-combustible

countertop opening

cabinet opening

below countertop

29 1/4” (74 3 cm)

27 1/2” (69.9 cm)

30” (76.2 cm)

2 9/16” 

(6.5 cm)

10” min.

(25.4 cm)

both sides

Countertop height: min: 35 7/16” (90.0 cm) max: 37 7/16” (95.1 cm) 

Notch countertop

overhang to width of

cabinets

3/8” min. (1.0 cm)

countertop

overhang

raised vent  opening

H

Combustible side

wall above range

below countertop

To cabinet face

To countertop

 front

J K

Cabinet face

Countertop

Range trim resting

on countertop

Back of

control

panel

DR30DI[H] range

3/8” min. (1.0 cm)

flat countertop

overhang required 

behind cutout

28 11/16” (72.9 cm)

3 1/4 inch

side panel

ERV3015

raised vent

3/8” min. (1.0 cm) space

required behind ERV3015

chassis to clear stiffener

H

Cutout tolerances: +1/16” (+1.6 mm), -0