Dacor DR30DH-C Benutzerhandbuch

Installation Instructions

Preparing for Installation

•

If the gas or electric service provided does not meet the 

product specifications, do not proceed with the installation. 

Call the dealer, the gas supplier or a licensed electrician.

•

Before installing the range, you must locate and secure the 

anti-tip bracket as instructed.

•

Be sure that the unit is not connected to gas or power 

before proceeding with the following sections.

IMPORTANT: Within the Commonwealth of Massachusetts, this 

appliance must be installed by a licensed plumber or gas fitter.

Unpack the range and verify that all required parts have been 

provided. If any item is missing or damaged, please contact 

your dealer immediately. Do not install a damaged or incomplete 

appliance. The customer must report cosmetic issues within 30 

days of installation.

•  2 grates
•  1 small standard burner cap
•  1 small standard burner ring
•  2 large standard burner caps
•  2 large standard burner rings
•  1 inner SimmerSear™ burner cap
•  1 outer SimmerSear burner cap
•  1 SimmerSear burner ring
•  2 standard oven racks
•  1 GlideRack oven rack
•  Anti-tip bracket w/screws and anchors
•  Meat probe
•  Dacor Stainless Steel Cleaner
•  Literature kit

Locate the anti-tip bracket included in the parts box.

•

Floor mounting (preferred method)

•

Wall mounting (alternate method). Use this method if floor 

mounting is not suitable. If the front panel of range is further 

than 27 1/2” (69.9 cm) from the back wall or if the flooring is 

too thick (see Installing the Anti-Tip Bracket on the Wall), 

the wall mounting method may not be used and the floor 

mounting method must be suitable.

To perform its intended function, the anti-tip bracket must be 

attached as instructed to the concrete slab or wood sub-floor 

below any floor coverings (including cement board) on top. Do 

not attach the anti-tip bracket directly to floor coverings such as 

ceramic/asphalt tile or linoleum.

Four (4) plastic anchors are provided along with three sizes (4 

each) of #8 or #12 Phillips head screws for attaching the anti-

tip bracket to the floor. Use both the anchors and four (4) of the 

screws when attaching the bracket to a concrete sub-floor. Do not 

use the anchors when attaching to a wood sub-floor.

Screws attached to sub-

floor below floor covering

Floor 

covering

Anti-tip 

bracket

Sub-floor

Concrete anchors shown, do 

not use for wood sub-floor