Dimplex dfb6016 Benutzerhandbuch

7

This section provides easy step 

by step instructions for selecting a 

location and preparing the site to 

install the fireplace into:

 NOTE 1:  A 15 Amp, 120 

Volt circuit is required.  A 

dedicated circuit is preferred 

but not essential in all cases.  

A dedicated circuit will be 

required if, after installation, 

the circuit breaker trips or 

fuse blows on a regular basis 

when the heater is operating.  

Additional appliances on the 

same circuit may exceed the 

current rating of the circuit 

breaker.

 WARNINg:  Ensure the 

power cord is not installed so 

that it is pinched or against a 

sharp edge and ensure that 

the power cord is stored or 

secured to avoid tripping or 

snagging to reduce the risk of 

fire, electric shock or injury to 

persons.

  Construction and electrical 

outlet wiring must comply 

with local building codes and 

other applicable regulations to 

reduce the risk of fire, electric 

shock and injury to persons.

  Do not attempt to wire your 

own new outlets or circuits.  To 

reduce the risk of fire, electric 

shock or injury to persons, 

always use a licensed 

electrician.

 NOTE:  The fireplace insert 

comes completely assembled 

and wired.  some tools may 

be required to prepare the site 

and assembly/install the trim.

  The dimensions of the 

fireplace insert are  30 ¼ inch 

(76.8 cm) wide X 25 ½ inch 

(64.8 cm) high X 11 ½ inch 

(29.2 cm) deep (Figure 1).  

  You should allow 1/4 inch 

(6.4 mm) around the fireplace 

insert for ease of installation.  

This fireplace does not require 

any venting.

 CAUTION:  Clearance for 

air circulation beneath the 

fireplace insert is provided by 

four (4) rubber feet (Figure 1).