Dyson cr01 Benutzerhandbuch

Every Dyson machine is tested before it is dispatched. As a

result, there may be some dampness or water in the machine.

The machine should not be installed in a location where the

temperature may drop below freezing.

The machine should not be installed in a bathroom.

The machine must be installed on a secure and flat surface.

Soft floors, such as carpet or carpet tiles, are not suitable

surfaces.

If the machine is to be installed on floorboards, the unit must

be placed on a water-resistant wooden board at least 30mm

thick with at least 50mm spare on each side of the machine.

This board must be screwed securely to at least two joists.

If possible, the machine should also be positioned in the

corner of the room.

The maximum distance and suggested layout of the drain,

taps and power socket from the machine are illustrated below.

The inlet water pipes, drain hose and the electrical mains

lead must be positioned carefully to avoid damage or kinking

when the machine is fully installed. The machine can be

connected to a standpipe, under sink pipe connection or

other drainage system, but the critical dimensions must be

followed.

Important

Stand pipe connection

Installation

Sink pipe connection

Water supply, drainage and electricity

The washing machine comes with:

2 inlet pipes (one blue, one red).

1 drainage hose hook.

1 Dyson spanner.

1 drainage hose located at the rear of the machine.

All of the above items can be found in the drums.

NB: the model ‘CRO1 Memory’ has leak protection hoses with

a small rectangular block at the end of the cold inlet pipe

which are different from those illustrated.

Hot inlet pipe

Cold inlet pipe

Drainage hose hook

Dyson spanner

600 mm
MAX.

450 mm
MIN.

600 mm
MAX.

450 mm
MIN.

•

Location

Refit the lid and two screws.

Open the outer door and carefully lift out the two foam inserts

from the front of the inner door.

Please retain the transit packaging for future use, as it should

be used whenever the machine is moved.

To replace the packaging, reverse the above procedure.

Moving

To move the machine, pull out the Rollerjack

handle from

under the front of the machine which enables you to

manoeuvre the machine easily into your desired position.

Replace the Rollerjack

slowly because the handle may return

with force. The Rollerjack

is not designed for moving the

machine over long distances.

Inner transit packaging removal

Before installation, check the washing machine for damage.

A qualified person should always carry out installation.

All packaging must be removed before the machine is

connected to power or water supplies.

Remove the rear panel by removing the five screws.

Carefully withdraw the foam block and then refit the rear

panel and screws.

Remove the two screws from the rear of the lid.

Remove the machine lid by sliding it rearwards and then up.

Remove the plug from under the lid by cutting the ties holding

it on to the transit bracket.

Using the Dyson spanner remove the four bolts securing the

top transit bracket.

Remove the four screws securing the bracket to the machine

casing and lift out the transit bracket.

Before installation

•