Wayne-Dalton 9700 Benutzerhandbuch
5
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages business listings or go to the
Find a Dealer section online at www.Wayne-Dalton.com
Tools Required
Removing An Existing Door
IMPORTANT: COuNTERBalaNCE sPRINg TENsION MusT alWays BE RElEasED BEfORE aNy aTTEMPT Is MaDE TO sTaRT REMOVINg aN
ExIsTINg DOOR.
ExIsTINg DOOR.
a POWERful sPRINg RElEasINg ITs ENERgy suDDENly CaN CausE sEVERE OR faTal INjuRy. TO aVOID INjuRy HaVE a
TRaINED DOOR sysTEMs TECHNICIaN, usINg PROPER TOOls aND INsTRuCTIONs, RElEasE THE sPRINg TENsION.
TRaINED DOOR sysTEMs TECHNICIaN, usINg PROPER TOOls aND INsTRuCTIONs, RElEasE THE sPRINg TENsION.
for detailed information see supplemental instructions “Removing an Existing Door /Preparing the Opening”. These instructions are available at no charge
from Wayne-Dalton, a Division of Overhead Door Corporation, P.O. Box 67, Mt. Hope, OH 44660, or at www.Wayne-Dalton.com.
from Wayne-Dalton, a Division of Overhead Door Corporation, P.O. Box 67, Mt. Hope, OH 44660, or at www.Wayne-Dalton.com.
WARNINg
POWER DRIll
RaTCHET WRENCH
PlIERs/WIRE CuTTERs
PHIllIPs HEaD sCREWDRIVER
PENCIl
1/8”, 3/16” DRIll BITs
flaT TIP sCREWDRIVER
7/16” sOCkET DRIVER
TaPE MEasuRE
NEEDlE NOsE PlIERs
7/16”, 1/2”, 9/16”
sOCkETs
3/8”, 7/16”, 1/2”, 9/16”
WRENCHEs
safETy glassEs
sTEP laDDER
(2) saW HORsEs
HaMMER
VICE gRIPs
VICE ClaMPs
glOVEs