Zebra Technologies R110Xi Benutzerhandbuch

Connect the Printer to a Power Source

23063L-003 Rev. 1 12/6/04

R110Xi/R170Xi User Guide

11

Turn the printer power switch (located on the rear of the printer) to the Off (O) position.

Plug the power cord into the mating connector on the rear of the printer.

Plug the other end of the power cord into the power source.

Depending on how your printer was ordered, a power cord may or may not be included. If one 
is not included or if the one included is not suitable for your requirements, refer to the 
following guidelines:

• The overall cord length must be less than 9.8 ft (3.0 m).
• The cord must be rated for at least 5 A, 250 V.
• The chassis ground (earth) must be connected to ensure safety and reduce electromagnetic 

interference. The third wire in the power cord grounds the connection (

).

• The AC power plug and the IEC 320 connector must bear the certification mark of at least 

one of the known international safety organizations shown in 

.

Caution • For personnel and equipment safety, always use an approved three-conductor 
power cord specific to the region or country intended for installation. This cord must use 
an IEC 320 female connector and the appropriate region-specific three-conductor 
grounded plug configuration.

AC power plug for your country

3-conductor HAR cable

IEC 320 connector

Neutral, earth, live in contact view

+

R