Manualsbrain.com
  1. Handbücher
  2. Marken
  3. Zebra Technologies
  4. R110Xi
  5. Benutzerhandbuch

Zebra Technologies R110Xi Benutzerhandbuch

Download
Seite von 184
42
R110Xi/R170Xi User Guide
23063L-003 Rev. 1 12/6/04
Front Panel Controls
Overview
Overview
After you have installed media and ribbon and printed a configuration label, you can change 
the printer’s settings using the front panel controls. For an overview of the front panel, 
including descriptions of the buttons and lights, see 
. If you need to 
restore the printer to its factory default settings, see 
.
Many printer settings may be controlled by your printer’s driver or label preparation software. 
Refer to the driver or software documentation for more information.
Enter Setup Mode
To enter Setup Mode, complete these steps:
1.
Press 
SETUP/EXIT
 to enter Setup Mode. 
2.
Press either 
NEXT/SAVE
 or 
PREVIOUS
 to scroll through the parameters.
Exit Setup Mode
To leave Setup Mode, complete these steps:
1.
Press 
SETUP/EXIT
.
The LCD displays 
SAVE CHANGES
.
2.
Press the left or right oval to display the save options (
).
3.
Press 
NEXT/SAVE
 to select the displayed choice.
When the configuration and calibration sequence is done, 
PRINTER READY
 displays.
Table 6 • Save Options When Leaving Setup Mode
LCD Display
Description
PERMANENT
Permanently saves the changes. Values are stored in the printer even when 
power is turned off.
TEMPORARY
Saves the changes until you change them again or until power is turned off.
CANCEL
Cancels all changes from the time you pressed 
SETUP/EXIT
 except the 
darkness and tear-off settings (if they were changed).
LOAD DEFAULTS
Sets all parameters other than the network settings back to the factory defaults. 
To see the factory default values, see 
Note • 
Loading factory defaults causes the printer to auto-calibrate. 
LOAD LAST SAVE
Loads values from the last permanent save.
DEFAULT NET
Sets the wired and wireless network settings back to factory defaults.