Fujitsu C120-E276-11ENZ0(A) Benutzerhandbuch

This chapter describes the summary of environment settings required after installing this product.
Install the driver and configure environment settings using the following procedures.

-

-

-

-

-

-

-

It is necessary to install the driver software stored on the CD-ROM that ships with the card to use this product. See the document "Installation
Guide FUJITSU PCI GigabitEthernet 4.1 Update2 / 5.0" for installation procedures.

In Solaris 11, The interface name is changed into the form of "net*" from the form of "fjgi*" by Vanity Naming.

This section explains how to identify the interface name of fjgi interface.

*1: Please put a decimal number (instance number) in place of the asterisk (*).
See section "

Execute the commands shown in the following examples.

dladm show-phys | grep fjgi

example:

# dladm show-phys | grep fjgi

net2              Ethernet             unknown    1000   unknown   fjgi0

net3              Ethernet             unknown    1000   unknown   fjgi1

net4              Ethernet             unknown    1000   unknown   fjgi2

net5              Ethernet             unknown    1000   unknown   fjgi3

The installed fjgi interface and the interface name are displayed.

 

The interface name (Vanity Name, the form of "net*")

fjgi interface (the form of "fjgi*")

net2

fjgi0

net3

fjgi1

net4

fjgi2

net5

fjgi3

In the above example, it is displayed that net2 is fjgi0, net3 is fjgi1, and net5 is fjgi3.

In addition, The interface name can be changed by dladm rename-link command. For more information about the dladm(1M) command,
please refer to the "System Administration Guide: IP Services" and the "man pages section 1M: System Administration Commands" of
Oracle Documentation.

- 11 -