Hoyt recurve-2002 Benutzerhandbuch
6
The weight marked on the lower limb is measured at a 28” stan-
dard A.M.O. (Archery Manufacturers and Merchants
Organization) draw length. A.M.O. draw length is measured at
26 1/4” to the throat of the bow grip plus 1 3/4”. This produces
an industry standard by which recurve bows are measured.
dard A.M.O. (Archery Manufacturers and Merchants
Organization) draw length. A.M.O. draw length is measured at
26 1/4” to the throat of the bow grip plus 1 3/4”. This produces
an industry standard by which recurve bows are measured.
Note: Your draw weight will change due to draw length. Add or
subtract approximately two pounds for each inch your draw
length is over or under the 28” standard.
subtract approximately two pounds for each inch your draw
length is over or under the 28” standard.
BOW ASSEMBLY
Installing Detent Limbs
Install one limb in each pocket (the limb noting specifications is
the bottom limb). Carefully insert the limb bushing into the
dovetail groove in the pocket. Push the limb forward until the
detent button engages. You should hear a “click” indicating the
limb is fully seated.
the bottom limb). Carefully insert the limb bushing into the
dovetail groove in the pocket. Push the limb forward until the
detent button engages. You should hear a “click” indicating the
limb is fully seated.
Draw Length 28”
Throat of Grip
(Pivot Point)
Throat of Nock
26.25”
1.75”