Hoyt recurve-2002 Benutzerhandbuch
8
Changing the Limb Hardware (Axis Riser)
All Hoyt limbs are shipped with the standard dovetail detent sys-
tem installed (Step #1). This configuration is used on all Hoyt ris-
ers with exception to the Axis. In order to use the limbs on the
Axis riser, Hoyt provides a convenient, quick-change system.
tem installed (Step #1). This configuration is used on all Hoyt ris-
ers with exception to the Axis. In order to use the limbs on the
Axis riser, Hoyt provides a convenient, quick-change system.
To remove the detent system (Step #2), turn the cap screw count-
er-clockwise to loosen. Once the cap is removed, pull the dove-
tail, detent and spring from the limb. You may wish to keep
these in a safe place for future use.
er-clockwise to loosen. Once the cap is removed, pull the dove-
tail, detent and spring from the limb. You may wish to keep
these in a safe place for future use.
To install the slot system (Step #3), insert the slot cylinder where
the detent system was previously. Replace the cap and securely
tighten to ensure a solid fit.
the detent system was previously. Replace the cap and securely
tighten to ensure a solid fit.
With the slot system installed (Step #4), your limbs can be shot
with the Axis riser. To change the limbs back to the detent sys-
tem, just follow the above instructions in reverse. Be sure to
include the detent and the spring when changing back to the
detent system.
with the Axis riser. To change the limbs back to the detent sys-
tem, just follow the above instructions in reverse. Be sure to
include the detent and the spring when changing back to the
detent system.
Step #1
Step #2
Step #4
Step #3
Slot System
Cap
Dovetail
Cap
Detent
Spring
Note: If your limbs were purchased prior to the 2000 product year, you will
need to purchase a limb conversion kit for your limbs in order to shoot the
limbs with the slot system.
need to purchase a limb conversion kit for your limbs in order to shoot the
limbs with the slot system.