bobcat t190 Benutzerhandbuch

The motor carriers have a reservoir in which the lubricant
must be replaced each time the track is replaced. (Track
removal is necessary.)

See your Bobcat dealer for track and motor carrier
lubricant replacement.

Check the torque of the six (6) track sprocket bolts (1)
[Figure 178] for the correct service interval. Use a cross-
pattern tightening sequence (A-B-C, D-E-F) [Figure 178]
and then repeat to tighten the bolts to 407 Nm torque.

Stop the engine.

Raise the operator cab. (See Raising on Page 74.)

Loosen the alternator mounting bolt (1) and adjustment
bolt (2) [Figure 179].

Move the alternator until the belt has 8,0 mm movement
at the middle of the belt span with 66 N of force.

Tighten the adjustment bolt and mounting bolt.

Lower the operator cab. (See Lowering on Page 75.)

Stop the engine.

Raise the operator cab. (See Raising on Page 74.)

Loosen the alternator mounting bolt (1) and adjustment
bolt (2) [Figure 179].

Move the alternator all the way toward the rear of the
loader.

Remove the belt and install new belt.

Move the alternator toward the front of the loader until the
belt has 8,0 mm movement at the middle of the belt span
with 66 N of force.

Tighten the adjustment bolt and mounting bolt.

Lower the operator cab. (See Lowering on Page 75.)

Check the belt tension after several hours of operation
and readjust as needed.

P-24478

P-24543