Lennox lss-ca35 Benutzerhandbuch

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.

Step 1. Install the top and bottom grills to their corresponding top
and bottom cast iron facade pieces as detailed in the installation
instructions provided with the grillwork kits.

Step 2. Install five (kit-provided) facade holding screws to each of
the two side pieces ensuring compliance with the gaps shown in
Figure 1.

Step 3. Hook the two cast iron side pieces onto the fireplace side
channels as shown in 

Figure 2. If the fit is too tight or loose, adjust the

gap of the two holding screws. (See

 Figure 1.)

Step 4.  Insert set screws into the bottom corners of the arch.  Set
screws should be flush with the front of the mounting bosses (refer to
Figure 4 ).

These cast iron facade kits  are designed to be used in conjunction with
the grillwork kits. Together, when installed, these kits complete the front
aspect of the  Spectra LSS series gas fireplaces. The kits contain one
of each of the following cast iron facade pieces: bottom, top, left and
right piece. They also contain four 1/2 inch long 1/4-20 facade holding
screws, six 1-1/2 inch long 1/4-20 facade holding screws and these
instructions.

HEARTH PRODUCTS

KITS AND ACCESSORIES