U-Line 2075R Benutzerhandbuch

www.U-LineService.com

02/2005

™

1. Plug in the power cord.

2. Gently push the unit into position. Be careful not to 

entangle the electrical cord. 

3. Re-check the leveling, from front to back and side to 

side. Make any necessary adjustments. The unit’s top 
surface should be approximately 1/8" below the 
countertop.

4. Remove the tape from the glass shelves and wipe out 

the inside of the unit with a clean, water-dampened 
cloth.

Both the glass shelves in the refrigerator and the inner 
door shelves can be moved to accommodate your bottles, 
cans and containers.

1. Open door fully, grasp shelf firmly, lift front edge 

slightly, and pull straight out.

2. Choose new location and slide shelf onto the 

appropriate rib.

1. See Figure 33. Pull shelf 

out about 6” to clear the 
wall’s molded protrusion.

2. Tilt right-hand edge of 

shelf up.

3. Keeping at this angle and 

hugging the right wall, 
pull the shelf out.

4. Choose new location and 

insert over ribs, tilting 
right-hand edge up. Push 
in, then lower shelf onto 
ribs.

1. First pull shelf up at a 45° 

angle, then straight out 
(see Figure 34).

2. Choose new location and 

line up on bosses. First 
push straight in, then 
down at a 45° angle.

The door remains open unless it is pushed closed.

The hinges should be self-closing when the door is open 
approximately 8". If this is not the case, make sure the 
closers (at the bottom of the hinge pin) are clean, greased 
and installed correctly. Also, re-check leveling from front 
to back of the unit and readjust if necessary. Make sure 
that pivot plate is installed correctly.

The custom overlay door was designed to align with the 
rest of the cabinet doors, but the unit has crept forward.

Make sure that the electrical cord is not obstructing the 
installation.

1. Pull Out 6"

2. Tilt

3. Pull

Boss

Notch