glen-canyon 720-0026-lp Benutzerhandbuch

Do not attempt to light the grill if odor of gas is 

present. Call for service 1-800-913-8999. 

Inspect the gas supply hose prior to turning the gas 

“ON”. If there is evidence of cuts, wear, or abrasion, it 

must be replaced prior to use. Do not use the grill if the 

odor of gas is present. Only the pressure regulator and 

hose assembly supplied with the unit should be used. 

Never substitute regulators for those supplied with the 

grill. If a replacement is necessary, contact the factory 

for proper replacement. 

 

Screw the regulator (type QCC1) onto the tank. Leak 

check the hose and regulator connections with a soap 

and water solution before operating the grill 

 

Make sure all knobs are “OFF” then turn on the gas 

supply from the LP tank. Always keep your face and 

body as far from the grill as possible when lighting. 

 

Your grill has an exclusive patented built-in ignition. 

The igniter is built in to the valve. To ignite each burner 

simply push and turn the control knobs to the HI 

setting, you will hear the valve click as it sends a spark 

to the pilot flame. If the burner does not light, wait 5 

minutes for any excess gas to dissipate and then retry. 

 

Check for proper burner flame characteristics. Each 

burner is adjusted prior to shipment; however, 

variations in the local gas supply may take minor 

adjustments necessary. 

 

Burner flames should be blue and stable with no 

yellow tips, excessive noise, or lifting. If any of 

these conditions exist call our customer service line. If 

the flame is yellow, it indicates insufficient air. If the 

flame is noisy and tends to lift away from the burner, it 

indicates too much air. 

If the burner will not light after several attempts then 

the burner can be match lit.   

 

If you’ve just attempted to light the burner with the 

igniter, allow 5 minutes for any accumulated gas to 

dissipate. Keep your face and hands as far away from 

the grill as possible. Insert a lit extended match or 

lighter through the cooking grids to the burner. Press 

the control knob and rotate left to the HI setting, 

continue to press the knob until the burner ignites. 

Burner should light immediately. If the burner does not 

light in 4 seconds turn the knob off, wait 5 minutes and 

try again. 

Open the lid; push the knob for about 5 seconds 

without rotating. This will allow time for the gas to flow 

into the rear burner. Continue pushing for 5 seconds 

then turn the knob to the HI position, then press the 

igniter button to light the rotisserie burner. If the burner 

does not light, turn the control knob to “OFF”. If the 

igniter does not function, follow the instruction above 

for match lighting. 

Keep a spray bottle of soapy water near the gas 

supply valve and check the connections before each 

use.