glen-canyon 720-0026-lp Benutzerhandbuch

TROUBLE SHOOTING

ROBLEM

SOLUTION

When I light the grill it does not flame

ou have turn on the gas

ing to ignite

y 5 second before to turn

er is clean.

--Make sure y

immediately.

--Make sure it has spark while you are try

the burner.

Push in for approximatel

and ignite the grill.

Make sure your burn

Rotisseries burner will not light when the

g the electrode

see there is spark that jumps to the

ion.

ser to the burner

when

--Check to see if debris is blockin

igniter button is pushed.

sparks.

Check to

burner from the electrode wire. If no spark is seen.

Check the battery located inside the button. Press

and turn counter clockwise.

Check for loose wire connect

--Gently bend the electrode wire clo

until a spark is seen to jump from the igniter to the

burner when you press the starter button.

Dose the infrared back burner light

attempting to match light? If not, check did you

turn on the gas.

Regulator makes noise.

--Vent hose on the regulator may be plugged or

on the regulator is not

er performance if the

regulator may be faulty.

Ensure the vent hole

obstructed. Clear the hole, close the LP tank and

gas control valves. Wait ten minutes and re-start.

When turning the LP tank valve on, do not cover

vent hole on the regulator.

Check your flames for prop

flames are not correct replace regulator.

Full size cover does not fit the grill.

ay be a

tight fit. Ensure the cover correct length for your

grill. Measure it left to right. Compare to the grill’s

measurement.

--Compare the location and size of the hood portion

of the cover to your grill.

--Spread the cover and allow it to relax, preferably in

warm sunlight or in a warm room.

Cover may be incorrect for your grill. It m