glen-canyon 720-0026-lp Benutzerhandbuch

Rotisserie motor will not turn

--Check the voltage at the outlet.

If an extension cord is required, ensure it is a 16

gauges, grounded cord.

Ensure the on/o

ff switch is on.

r drag.

--Ensure the load does not exceed the 40 pounds

operational capacity.

--Ensure the spit is fully inserted in the motor.

Ensure there is no encumbrance o

Grill

only

heats

200-300

degrees.

sure the temperature gauge is functioning

properly. Hold a flame to the probe or compare the

eter place in the

cedure. Prior to lighting

f. The

the way on.. Turn left burner

t for

--En

grill gauge to an oven thermom

grill.

Ensure correct start pro

grill, the gas control knobs should be of

propane bottle should be off. If not, wait 15

minutes. Turn tank all

to ignite, wait 5 seconds ignite. Repea

additional burners.

--Check all gas connections for leaks with bubble

test. If leaks are found, replace the part or tighten

the fitting.

Grill takes a long time to preheat.

--Normal preheat 500-600degrees, takes about

10-15 min. Cold weather and wind may effect your

preheat time.

If you are using volcanic rock or briquettes they

can increase the preheat time and maximum

temperature.

Burner flames are not light blue.

n affect the mixture. Burner adjustment

may be required. Refer to manual for adjustment

--Too much or not enough air mixes for the flame.

--Elevation is the principal cause, however cold

weather ca

procedures.

--Grill is in a windy location.