UMAX e3000 Merkblatt
C.Setup DNS
1.Domain Name Servers are used to map an IP address to the equivalent
domain name. Your ISP should provide the IP address for one or more
domain name servers. Enter those addresses on this screen.
2.Press[Finish]button .
You've successfully configured the e3000.
domain name. Your ISP should provide the IP address for one or more
domain name servers. Enter those addresses on this screen.
2.Press[Finish]button .
You've successfully configured the e3000.
D.System Status
1. Click on Advanced Setup.
2. Click on System.
3. Click on Status.
2. Click on System.
3. Click on Status.
You can use the Status screen to see the connection status for the Sharing
Router WAN/LAN interfaces, firmware and hardware version numbers, and
the number of connected clients to your network.
(If your WAN IP, Subnet Mask, and Gateway are 0.0.0.0 then see
instructions to reset your router.)
Router WAN/LAN interfaces, firmware and hardware version numbers, and
the number of connected clients to your network.
(If your WAN IP, Subnet Mask, and Gateway are 0.0.0.0 then see
instructions to reset your router.)