multicoat crackrepair Benutzerhandbuch
DESCRIPTION AND USE
The MULTICOAT SPEED BOND CRACK
REPAIR SYSTEM is a unique two component
waterbased polyurethane material. SPEED
BOND is used to repair cracks, holes, and
depressions prior to the application of Krete
Kote, Slatex or Scratch Kote Systems.
SPEED BOND is also an excellent anchoring
material.
ADVANTAGES
●
Eliminates recurrence of most surface
cracks
●
Easy to use and install
●
Fast set up/Minimum downtime
●
Waterbased – environmentally safe to use
and apply
SEE TEST DATA
SURFACE PREPARATION
All cracks larger than
1
⁄
16
" in width must be
opened with a crack chaser to a minimum of
1
⁄
4
" in width. Once opened, all cracks must be
cleaned by sandblasting, waterblasting or
water sandblasting.
NOTE: Cleaning out prepared cracks may be
done in conjunction with substrate
preparation (See Krete Kote / Slatex
Systems).
APPLICATION
Fill properly prepared cracks with SPEED
BOND material. Backer rod or sand should
be placed in cracks where depths are
greater than
3
⁄
8
". Inject SPEED BOND
material into crack, level with the surface of
the substrate. (Note: Follow directions on the
cartridge carefully when using material).
After dispensing, immediately spread SPEED
BOND flush with deck surface using a plastic
spreader. Allow to harden 30-60 minutes
(depends on ambient temperature) then
grind SPEED BOND material to lightly abrade
surface.
Now you are ready to coat over the repaired
crack(s) with MULTICOAT Products and
Systems.
COVERAGE
One Speed Bond cartridge will fill approximate-
ly 20 linear feet of crack
3
⁄
8
" wide x
3
⁄
8
" deep.
CRACKS ROUTED OUT
IMMEDIATELY SPREAD WITH 4" PLASTIC PUTTY
KNIFE
LIGHTLY SAND SURFACE WITH 7" GRINDER OR
RUBBING STONE
CRACK REP
AIR SYSTEM
A Premier Crack Repair System
for Concrete Restoration.
FILL CRACK WITH
SPEED BOND
CRACK IS REPAIRED AND READY TO BE COATED
WITH MULTICOAT PRODUCTS AND SYSTEMS