Panasonic TX32DW334 Bedienungsanleitung

English   - 6 -

If the TV does not receive any input signal (e.g.  from 

an aerial or HDMI source) for 5 minutes, it will go 

into standby. When you next switch-on, the following 

message will be displayed: 

for a long time.” Press OK to continue.
If the TV is on and it isn’t being operated for a while 

it will go into standby. When you next switch-on, the 

following message will be displayed. 

was made for a long time.” Press OK to continue.

1.  Up direction
2.  Down direction
3.  Volume / Info / Sources List selection and 

Standby-On switch

The Control button allows you to control the Volume 

/ Programme / Source and Standby-On functions of 

the TV.
To change volume: Increase the volume by pushing 

the button up. Decrease the volume by pushing the 

button down.
To change channel: Press the middle of the button, 

the information banner will appear on the screen. 

Scroll through the stored channels by pushing the 

button up or down.
To change source: Press the middle of the button 

twice(for the second time in total), the source list will 

appear on the screen. Scroll through the available 

sources by pushing the button up or down.
To turn the TV off: Press the middle of the button 

down and hold it down for a few seconds, the TV will 

turn into standby mode.
Notes: 
• If you turn the TV off, this circle starts again 

beginning with the volume setting.

• Main menu OSD cannot be displayed via control 

button.

Operation with the Remote Control
Press  the 

Menu button on your remote control to 

display main menu screen. Use the directional buttons 

to select a menu tab and press 

OK to enter. Use the 

directional buttons again to select or set an item. Press 

Return/Back or Menu button to quit a menu screen.
Input Selection
Once you have connected external systems to your 

TV, you can switch to different input sources. Press the 

Source button on your remote control consecutively 

to select the different sources.
Changing Channels and Volume
You can change the channel and adjust the volume 

by using the 

Volume +/- and Programme +/- buttons 

on the remote. 

Lift the cover on the back of the remote gently. Insert 

two 

AA batteries. Make sure the (+) and (-) signs 

match (observe correct polarity). Place the cover 

back on.

IMPORTANT: The TV set is designed to operate on 

220-240V AC, 50 Hz socket. After unpacking, allow 

the TV set to reach the ambient room temperature 

before you connect the set to the mains. Plug the 

power cable to the mains socket outlet.

Connect the aerial or cable TV plug to the AERIAL 

INPUT (ANT) socket or satellite plug to the SATELLITE 

INPUT (LNB) socket located on the back of the TV.