Panasonic VDRM75EB Bedienungsanleitung
46
Removing Disc
1
2
Open the cover by
hand and remove the
disc.
hand and remove the
disc.
While pressing down
on the spindle, grasp the
edge of the disc and
gently lift it out.
on the spindle, grasp the
edge of the disc and
gently lift it out.
Note
:
•
Do not use excessive force
when opening the cover.
when opening the cover.
•
Do not touch the pickup
lens or the recording/
playback side of the disc.
lens or the recording/
playback side of the disc.
•
If the disc cover is open, the power will not turn off even
if the power switch is set to “OFF”.
if the power switch is set to “OFF”.
•
When you open the lid, the ACCESS/PC indicator
flashes red. Do not leave the lid open.
flashes red. Do not leave the lid open.
3
Gently push the section
labelled “PUSH CLOSE”
on the cover of disc
insertion block, to close
the cover.
labelled “PUSH CLOSE”
on the cover of disc
insertion block, to close
the cover.
Note
:
•
It is recommended that you turn the DVD Video Camera off
before inserting or removing disc to prevent misoperation.
before inserting or removing disc to prevent misoperation.
•
If the disc cover is open, the power will not turn off even
if the power switch is set to “OFF”.
if the power switch is set to “OFF”.
•
Do not remove the battery or disconnect the AC adaptor/
charger during removal of the disc or until power is
completely turned off: If you do, the disc cover will not
open. If this happens, reattach the battery or AC adaptor/
charger, push down the DISC EJECT lever once, and
then release it.
charger during removal of the disc or until power is
completely turned off: If you do, the disc cover will not
open. If this happens, reattach the battery or AC adaptor/
charger, push down the DISC EJECT lever once, and
then release it.
•
Do not insert anything other than the 8 cm DVD-RAM or
DVD-R disc into the disc insertion block: Doing so could
cause malfunctions.
DVD-R disc into the disc insertion block: Doing so could
cause malfunctions.
•
Set the power switch to “OFF” to turn the DVD Video
Camera off.
Camera off.
•
When inserting or removing the disc, be careful not to
touch the inside of DVD Video Camera [especially, the
lens of laser pickup (see “Terminology” on page 160)].
touch the inside of DVD Video Camera [especially, the
lens of laser pickup (see “Terminology” on page 160)].
•
When inserting or removing the disc, connect a charged
battery or AC adaptor/charger to the DVD Video Camera:
The disc cover will not open unless the DVD Video
Camera is powered.
battery or AC adaptor/charger to the DVD Video Camera:
The disc cover will not open unless the DVD Video
Camera is powered.
Press down the DISC EJECT
lever once and release it.
lever once and release it.
In a moment, the
cover of disc
insertion
compartment
will open
slightly.
cover of disc
insertion
compartment
will open
slightly.
Pickup lens
VDR-M75M55EB.book Page 46 Tuesday, May 17, 2005 10:32 AM