Panasonic CZCSWKC2 Bedienungsanleitung

Click on a registered floor name to display a list of indoor units registered on that 
floor in the indoor unit column on the right side of the screen.

Double click to change the name of a floor. It is also possible to change part of the 
name of a previously-registered floor. To change the entire name, just type in the 
name. The existing name will be deleted and the new name displayed.
Once the name has been changed, click on the 

 button to register it. Click on 

the 

 button to revert to the previously registered state.

To enable the registered content, click in the Enable space to add a check mark.
Click there again to remove the check mark, disabling the setting.
* The Level and Main No. cannot be set if the floor is not enabled.

Click in the Level cell to display the 

 button, then click on it. The list for 

selecting levels appears. Make a selection. The selectable levels are 2 and 3.

*  Level 1 is used for overall display, so it cannot be selected.
*  When setting Level, set to Enable.
*  Settings cannot be changed where the Level cell is grayed out

.

Click in the Main No. cell to display the 

 button, then click on it.

A list of Main numbers is displayed, so specify the relevant Main No.

*  If Level 2 was set, the Main No. is set unconditionally to 1 and cannot be changed.
*  When setting the Main No., set to Enable.
*  Settings cannot be changed for cells where the Main No. is grayed out..