Cisco 2811 ROUTER 2FE 1NME 4HWIC 2PVDM 2AIM IP BASE WITH A/C POWER SUPPLY Техническое Руководство

The PVDM connectors are located on the system board, and are identified as follows:

In Cisco 2801 and Cisco 2811 routers—PVDM 0 and PVDM 1 

In Cisco 2821 and Cisco 2851 routers—PVDM 0, PVDM 1, and PVDM 2

Refer to 

 for PVDM locations.

PVDMs have a polarization notch on the mating edge to prevent incorrect insertion. 

 shows the 

polarization notch on a PVDM.

To remove a PVDM from the system board, follow these steps:

Locate the PVDM on the system board. See 

, 

, 

, depending on 

your router model, for the location of the PVDMs. 

Pull the PVDM retaining clips away from the PVDM at both ends, and then tilt the PVDM until it can 
be freely removed from the connector. See 

PVDMs must be removed in order—PVDM 1 then PVDM 0 in Cisco 2801 and 2811 routers, and 
PVDM 2, then PVDM 1, then PVDM 0 in Cisco 2821 and 2851 routers.

Polarization notch

103363

Alignment holes