Cisco 7500 SERIES ROUTE SWITCH PROCESSOR 16 Техническое Руководство

If you disconnected the console terminal to remove the RSP16, or if you are installing a new RSP16,
connect the console terminal to the console port. (See the

.)

Ensure that a console terminal is connected (see the

) and that it is turned on.

Turn the system power back on, and proceed to the

to check

the installation.

This completes the procedure for replacing the RSP16.

The system console port on the RSP16 is a DB-25 receptacle DCE port for connecting a data terminal,
which you need to configure in order to communicate with your system. The console port is located on
the RSP16 just below the auxiliary port, as shown in

, and is labeled Console.

Before connecting the console port, check the documentation for your terminal to determine the baud
rate of the terminal you are using. The baud rate of the terminal must match the default baud rate (9600
baud). Set up the terminal as follows: 9600 baud, 8 data bits, no parity, and 2 stop bits (9600,8N2).

Use the console cable provided to connect the terminal to the console port on the RSP16, and then follow
the steps in the

.

Both the console and auxiliary ports are asynchronous serial ports; any devices connected to these ports
must be capable of asynchronous transmission. (Asynchronous is the most common type of serial device;
for example, most modems are asynchronous devices.)

H3538

Modem

Console terminal

Auxiliary 
port

Console 
port

DB-25 female

DB-25 male

RSP