Cisco 7500 SERIES ROUTE SWITCH PROCESSOR 16 Техническое Руководство
68
Route Switch Processor (RSP16) Installation and Configuration Guide
OL-4661-03
Troubleshooting the Installation
Troubleshooting a Failed RSP16
This section describes actions that you can take to correct or obtain information when an RSP fails. It
includes the following topics:
includes the following topics:
•
•
•
•
Troubleshooting RSP Boot Errors During OIR of an Interface Processor
If you have a Cisco 7507 or a Cisco 7513 with an RSP16 configured as the system standby, we strongly
recommend that you use the following procedure to remove and replace an interface processor:
recommend that you use the following procedure to remove and replace an interface processor:
Step 1
Remove the standby RSP.
Step 2
Wait 15 seconds.
Step 3
Remove and replace the interface processor, using the procedures in the configuration note that shipped
with your interface processor or in the Cisco 7500 Series Installation and Configuration Guide.
with your interface processor or in the Cisco 7500 Series Installation and Configuration Guide.
Step 4
Wait 15 seconds.
Step 5
Reinsert the standby RSP.
This completes the procedure to remove and replace an interface processor.
Reloading a Failed RSP
When a new active RSP takes over ownership of the router, it automatically reboots the failed RSP as
the standby RSP. You can also manually reload the failed RSP.
the standby RSP. You can also manually reload the failed RSP.
To manually reload a failed RSP from the active console, use the following command in privileged
EXEC configuration mode:
EXEC configuration mode:
Command
Purpose
Router# hw-module sec-cpu reset
Reloads the inactive standby RSP card.