Alpine MRV-V500 Benutzeranleitung
3
-EN
INSTALLATION
Due to the high power output of the MRV-V500
considerable heat is produced when the amplifier
is in operation. For this reason, the amplifier should
be mounted in a location which will allow for free
circulation of air, such as inside the trunk. For
alternate installation locations, please contact your
authorized Alpine dealer.
considerable heat is produced when the amplifier
is in operation. For this reason, the amplifier should
be mounted in a location which will allow for free
circulation of air, such as inside the trunk. For
alternate installation locations, please contact your
authorized Alpine dealer.
1. Using the amplifier as a template, mark the four
screw locations.
2. Make sure there are no objects behind the
surface that may become damaged during
drilling.
drilling.
3. Drill the screw holes.
4. Position the MRV-V500 over the screw holes, and
4. Position the MRV-V500 over the screw holes, and
secure with four self-tapping screws. (Fig. 1)
Self-Tapping Screws (M4 × 20)
Holes
Holes
Chassis
Ground Lead
Fig. 1
NOTE:
• To securely connect the ground lead, use an
• To securely connect the ground lead, use an
already installed screw on a metal part of the
vehicle (marked ( )) or a clean, bare metal spot
on the vehicle’s chassis. Be sure this is a good
ground by checking continuity to the battery (–)
terminal. Connect all equipment to the same
ground point while keeping wire length as short
as possible. These procedures will help eliminate
noise.
vehicle (marked ( )) or a clean, bare metal spot
on the vehicle’s chassis. Be sure this is a good
ground by checking continuity to the battery (–)
terminal. Connect all equipment to the same
ground point while keeping wire length as short
as possible. These procedures will help eliminate
noise.
ATTACHING THE
TERMINAL COVERS
TERMINAL COVERS
Attach the terminal covers (included) after
connections and confirmation of correct operation.
Attaching the terminal covers will improve the
appearance of the unit.
connections and confirmation of correct operation.
Attaching the terminal covers will improve the
appearance of the unit.
How to attach the terminal covers:
Attach the terminal covers to the main unit. (Fig.2)
Attach the terminal covers to the main unit. (Fig.2)
Terminal Covers
Fig. 2
CAUTION
Do not lift or carry the unit by the attached
terminal covers.
terminal covers.