Q-Logic Q-Forms Kick Panel Enclosures Benutzeranleitung

DRIVER & PASSENGER Side:

Pull the factory kick panel away from the metal bulkhead releasing snap clips.  Make

sure all of the snap clips are removed from the metal bulkhead.

Before you can begin the installation of your Q-Forms kick panels you will need to remove a foam

support under the carpet near the driver’s side kick panel.  Begin by pulling the carpet back away

from the floor pan.  Cut the rubber mat along the dotted lines represented in PICTURE A.

Remove the cut piece from the vehicle and place carpet back in original position. (PICTURE B)

Cut the speaker holes in the Q-Forms before installing the panels in the vehicle.  Using a hole saw of the

correct size, position the pilot drill on the dimple at the center of the speaker mounting surface.  Be careful as

the hole saw exits the rear of the panel.  Install speaker wiring and crossover network as per manufacturer’s

instructions.  Install tweeters as per manufacturer’s instructions.  Install midrange drivers after Q-Forms panels

have been installed in the vehicle.

DRIVER’S Side:

Lay the Q-Forms kick panel into place in the approximate location and connect the speaker wiring.     Install the

kick panel into the permanent position previously held by the original kick panel.  Press the panel firmly down

against the carpet.  Drill a 1/8” pilot hole into the metal behind the panel using the pre-drilled hole in the panel

in front of the hood release as a guide.  Secure the panel using the supplied 1/2” sheet metal screw.  Lay the

supplied polyfill in and around the opening for the midrange driver.  Install the midrange driver as per

manufacture’s instructions.  Be sure to center driver in opening to allow clearance for the speaker grill.

Picture B

Picture A