Brandmotion FDMC-1220 Benutzeranleitung

1220 Instructions 6-26-14.docx

Page 1 of 5

2013 – Current Ford Fusion Qi Wireless Charging Kit

(Kit # FDMC-1220)

Please read thoroughly before starting installation and check that kit contents are complete.

Items Included in the Kit:

Tools & Supplies Needed:

Qi Wireless Charging Module with

Fusion Specific Substrate and Mat

Power Harness with 3 amp Fuse
4 – Pan Head Torx 3/8” Screws
These Instructions with Template
Removable Consumer Product Label

Plastic Trim Removal Tool

T-15 Torx Drivers
7mm Socket Drive
13mm Socket Drive
Center Punch/Scribe Tool
Power Drill
3/16’’ and 1/2” Drill Bits

Wire Ties
Soldering Iron & Solder

(Recommended)

Tape or Heat Shrink Electrical Tubing

*Note this product is designed to work with Qi compatible devices. Please confirm that
your device is Qi compatible before installation. Visit

www.brandmotion.com

for phone

compatibility guide.

Safety Precautions:

• Work in well ventilated area that is clear of obstructions.

• Secure vehicle with tire chucks in both front and rear of tires.

• Turn vehicle accessories OFF and ensure ignition key is in OFF position.

• Wear safety goggles and snug fitting clothes.

• Use tools only for their intended purpose and which are in good repair.

• Only perform this task if confidence, skill, and physical ability permit.

NOTE: We strive to provide accurate and up-to-date installation instructions.

IMPORTANT: Do not place smart keys
within 6 inches of charging mat.
Vehicle may not detect key to start
vehicle. Do not place metal objects in
tray while charging.