Brandmotion FDMC-1220 オーナーマニュアル
1220 Instructions 6-26-14.docx
Page 1 of 5
2013 – Current Ford Fusion Qi Wireless Charging Kit
(Kit # FDMC-1220)
Please read thoroughly before starting installation and check that kit contents are complete.
Items Included in the Kit:
Tools & Supplies Needed:
Qi Wireless Charging Module with
Fusion Specific Substrate and Mat
Power Harness with 3 amp Fuse
4 – Pan Head Torx 3/8” Screws
These Instructions with Template
Removable Consumer Product Label
4 – Pan Head Torx 3/8” Screws
These Instructions with Template
Removable Consumer Product Label
Plastic Trim Removal Tool
T-15 Torx Drivers
7mm Socket Drive
13mm Socket Drive
Center Punch/Scribe Tool
Power Drill
3/16’’ and 1/2” Drill Bits
7mm Socket Drive
13mm Socket Drive
Center Punch/Scribe Tool
Power Drill
3/16’’ and 1/2” Drill Bits
Wire Ties
Soldering Iron & Solder
Soldering Iron & Solder
(Recommended)
Tape or Heat Shrink Electrical Tubing
*Note this product is designed to work with Qi compatible devices. Please confirm that
your device is Qi compatible before installation. Visit
your device is Qi compatible before installation. Visit
www.brandmotion.com
for phone
compatibility guide.
Safety Precautions:
• Work in well ventilated area that is clear of obstructions.
• Secure vehicle with tire chucks in both front and rear of tires.
• Turn vehicle accessories OFF and ensure ignition key is in OFF position.
• Wear safety goggles and snug fitting clothes.
• Use tools only for their intended purpose and which are in good repair.
• Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions.
IMPORTANT: Do not place smart keys
within 6 inches of charging mat.
Vehicle may not detect key to start
vehicle. Do not place metal objects in
tray while charging.
within 6 inches of charging mat.
Vehicle may not detect key to start
vehicle. Do not place metal objects in
tray while charging.