Trust 750 LCD Powerc@m Betriebsanweisung
TRUST 750 LCD POWERC@M ZOOM
2
This device meets the essential requirements and other relevant conditions of the
applicable European directives. The Declaration of Conformity (DoC) is available at
www.trust.com/13404/ce.
applicable European directives. The Declaration of Conformity (DoC) is available at
www.trust.com/13404/ce.
4
Inserting the batteries
1.
Open the battery compartment (10, figure 2) on the side of the camera by
sliding the cover downwards.
sliding the cover downwards.
2.
Insert the two AA alkaline batteries as shown on the inside of the battery flap.
3.
Close the battery compartment again by pushing it closed and sliding it into
place.
place.
4.
The TRUST 750 LCD POWERC@M ZOOM is now ready for use.
Note:
Inserting the batteries incorrectly may cause damage to the
camera. The warranty will then no longer be valid.
camera. The warranty will then no longer be valid.
Note:
Standard AA NiCd batteries are unsuitable for use with this
device.
device.
Note:
You can also use rechargeable AA NiMH batteries (minimum
1800 mAh) with the Trust 750 LCD PowerC@m Zoom.
1800 mAh) with the Trust 750 LCD PowerC@m Zoom.
Note:
The batteries will not be recharged when the camera is
connected to a USB port on your computer.
connected to a USB port on your computer.
5
Camera functions
This chapter gives a description of the various buttons and the information on the
LCD screen. The next chapter gives a step-by-step explanation of how the camera
can be used.
See figure 1 and table 1 below for a description of the various functions on the front
of the camera.
LCD screen. The next chapter gives a step-by-step explanation of how the camera
can be used.
See figure 1 and table 1 below for a description of the various functions on the front
of the camera.
Function
Description
1
Flash
Use the built-in flash to give the subject extra
lighting if it is in dark surroundings.
lighting if it is in dark surroundings.
2
ON/OFF button +
lens protector
lens protector
This button is also the lens protector. The
camera is turned on by sliding the lens protector
open. The camera is turned off by sliding the
lens protector closed.
Note: The camera turns off automatically when it
has not been used for approximately 1 minute.
camera is turned on by sliding the lens protector
open. The camera is turned off by sliding the
lens protector closed.
Note: The camera turns off automatically when it
has not been used for approximately 1 minute.
3
Lens
Records the image to be taken.
Note: Keep the lens clean. Dirt and fingerprints
affect the result.
Note: Keep the lens clean. Dirt and fingerprints
affect the result.
4
Exposure button
Press this button to take photographs or to
start/stop recording a short video clip.
start/stop recording a short video clip.
5
Automatic
exposure indicator
exposure indicator
Flashes when the automatic exposure function is
used.
used.
6
Red eye reduction
LED
LED
Removes the red-eye effect from the
photograph.
photograph.