Intertex Data AB IX78 Benutzerhandbuch
- 8 -
AD CFG
DHP
RST
LQ
TX
RX
TX
RX
No Ethernet packets at all received. This may be OK, but check your settings, see 3.2 and
3.4.
3.4.
If no error messages are shown, then your Internet connection is OK. Any remaining error is probably
due to your PC’s settings. See 3.2 for more information!
due to your PC’s settings. See 3.2 for more information!
3.5 Reset
to
Factory
Defaults
If you wish to you can reset all settings to their original values, so your ADSL Internet Gate is set up
the same way as when delivered from the factory.
the same way as when delivered from the factory.
1. Press and hold SET pressed for 3 seconds, to enter setup mode.
AD
CFG
DHP RST
LQ
TX
RX
TX
RX
2. Press
SEL repeatedly until ”RST” appears in the display.
AD
CFG
DHP
RST
LQ
TX
RX
TX
RX
3. Press
SET .
4. The question ”Clear all?” appears, and then ”no”.
5. Press
SEL to choose ”YES”.
AD CFG
DHP
RST
LQ
TX
RX
TX
RX
6. Press
SET .
7. The ADSL Internet Gate now resets and then restarts.
AD CFG
DHP
RST
LQ
TX
RX
TX
RX
4
Configuring Your ADSL Internet Gate
Your ADSL Internet Gate is delivered with factory settings that fit most users. In some situations
however, you need to change the configuration of your ADSL Internet Gate. All the configuration
pages can be reached from the main menu in the ADSL Internet Gate. You can also easily set up the
ADSL Internet Gate to fit your specific needs.
however, you need to change the configuration of your ADSL Internet Gate. All the configuration
pages can be reached from the main menu in the ADSL Internet Gate. You can also easily set up the
ADSL Internet Gate to fit your specific needs.
In the following sections you will find information about two of the configurable features in the ADSL
Internet Gate. For more information refer to the built in help or the online user manual, see also
section 2.
Internet Gate. For more information refer to the built in help or the online user manual, see also
section 2.
Note:
When you have made changes in the GUI, click Apply to activate the settings. To save the settings
permanently click on Save permanently at the top of the page. Changes that are not permanently
saved will disappear if the unit is restarted. When there are changes that have not been saved
permanently a warning is displayed at the top of the page as well as the text CFG in the display.
When you have made changes in the GUI, click Apply to activate the settings. To save the settings
permanently click on Save permanently at the top of the page. Changes that are not permanently
saved will disappear if the unit is restarted. When there are changes that have not been saved
permanently a warning is displayed at the top of the page as well as the text CFG in the display.