Schneider Electric Pty. Ltd. S1B15258 Benutzerhandbuch
9 of 20
5200UZI WHC2_5921 and 5200EZI WHC2_5922
USB ZB Interface and Ethernet ZB Interface User’s Manual
© 2012 Schneider Electric. All Rights Reserved.
5.0 Installation
The installation steps for the USB and Ethernet ZB interfaces differ slightly. The
following sections tell you how to install the type of interface you are using. This
User’s Manual assumes that you have a working ZigBee network and that you have
access to the CIS Web site on the Internet.
If you are installing multiple ZB interfaces at a site, perform the connection and
commissioning steps for each network separately. Note that only one ZB interface of
either type can communicate with a single ZigBee network. If you are working with
multiple ZigBee networks, be sure to give them unique names using Zoolkit.
following sections tell you how to install the type of interface you are using. This
User’s Manual assumes that you have a working ZigBee network and that you have
access to the CIS Web site on the Internet.
If you are installing multiple ZB interfaces at a site, perform the connection and
commissioning steps for each network separately. Note that only one ZB interface of
either type can communicate with a single ZigBee network. If you are working with
multiple ZigBee networks, be sure to give them unique names using Zoolkit.
5.1 USB ZB Interface Unit
Read the requirements before installing the USB ZB Interface.
Requirements
• Load the Zoolkit software application on the PC. The USB ZB interface unit
requires special hardware driver files that are included with Zoolkit. The software
setup program can be freely downloaded from the CIS Web site:
http://www.clipsal.com/cis/ On the Technical page, select Downloads.
setup program can be freely downloaded from the CIS Web site:
http://www.clipsal.com/cis/ On the Technical page, select Downloads.
• There must be a free USB port on the PC. At this time Zoolkit runs only on a
Windows operating system. For other system requirements, refer to Zoolkit
documentation.
documentation.
• There must be a working ZigBee network that the interface unit can join. The
typical range limit for reliable connectivity is 20 metres.
• If you are installing the USB ZB interface in a Wiser Home Control, you should
configure the Wiser unit (with Toolkit and PICED software) before installing the
USB ZB interface. Zoolkit software is designed to work with the Wiser unit. Refer
to the Wiser Home Control installation documents.
USB ZB interface. Zoolkit software is designed to work with the Wiser unit. Refer
to the Wiser Home Control installation documents.
Follow these steps when installing the USB ZB Interface.
1. Start the Zoolkit software application on the PC where you plan to install the
USB ZB interface unit. If you are using a Wiser Home Control as the location for
the interface unit, the Wiser unit must be operational.
the interface unit, the Wiser unit must be operational.
2. Install the USB ZB interface unit in an active USB port on the PC or in the
special location provided under the cover of the Wiser Home Control unit. Refer
to Figure 2 and Figure 7 for more information.
The power indicator should be on and the ZigBee status LED should be in the
Orange - continuous state.
to Figure 2 and Figure 7 for more information.
The power indicator should be on and the ZigBee status LED should be in the
Orange - continuous state.
3. Make certain that only one local ZigBee network is available for the interface unit
to join. Make sure that the network is within range and is currently operational.
4. Set the ZigBee network in its setup mode so that the interface unit can join.
Continued on the next page.