Schneider Electric Pty. Ltd. S1B15258 Benutzerhandbuch

8 of 20

5200UZI WHC2_5921 and 5200EZI WHC2_5922

USB ZB Interface and Ethernet ZB Interface User’s Manual

4.0 Switch Buttons and Indicators

The switch buttons and indicators (LEDs) are used during connection to the network
and also provide status information. Figure 6 shows the location of the buttons and
LEDs on the interface units.

USB ZB Interface

5200UZI WHC2_5921

Ethernet ZB Interface

5200EZI WHC2_5922

Reset button
Setup button

Back side

Front side

LEDs

Power LED

ZigBee LED

Power

Ethernet
ZigBee

Reset button
Setup button

Figure 6. Location of switch buttons and LEDs on the interface units.

The

Setup Button is used for E-mode actions, such as joining a ZigBee network or

disconnecting from a ZigBee network.

The

Reset Button restores the ZigBee settings to the default values. On the EZI ZB

interface unit to reset the IP configuration, you must ‘long-press’ the SETUP button.

The

Power LED indicates that the interface unit is connected to a suitable source of

power.

The

ZigBee LED shows the current state of the connection to a ZigBee network.

Refer to the table.

The

Ethernet LED (Ethernet ZB Interface only) shows the state of the connection to

the local Ethernet network.

Indicator State

Meaning

Orange - continuous

Not joined to a network.

Orange - flashing slowly

Attempting to join a network.

Green - continuous

Connected to a network. If no open network is found
within 30 seconds, the LED goes back to the Orange-
continuous mode.

Green - flashing

Responding to a ZigBee identity request

Off

Connected to an active network.

Red - flashing

Failed due to an error (such as multiple networks open).
The LED will flash Red two times slowly and then go back
to Orange-continuous mode.

Orange - flashing rapidly

Firmware is being updated--do not unplug