Diffraction Limited MD1 Benutzerhandbuch
MaxDome
26
Normal Operation
Please see
Dome Setup
and
Slaving Setup
if you have not already set up the
dome and telescope.
Connecting
Make sure that the Dome and Telescope have been properly selected. Note that
a Telescope Simulator and Dome Simulator are available if you wish to
experiment with the software without the hardware being present.
Click the Connect button. The dome and telescope should now be connected. If
you get an error message, check the connections.
a Telescope Simulator and Dome Simulator are available if you wish to
experiment with the software without the hardware being present.
Click the Connect button. The dome and telescope should now be connected. If
you get an error message, check the connections.
Opening the Shutter
Click the Open button. The dome should start opening within ten seconds (it has
to wait for the next radio message, which is sent every ten seconds). The dome
will take about 90 seconds to fully open. The shutters are opened one after the
other, and the total motor running time is conservative to ensure that each slit
fully opens.
When the open cycle is complete, the status will display Shutter is open.
to wait for the next radio message, which is sent every ten seconds). The dome
will take about 90 seconds to fully open. The shutters are opened one after the
other, and the total motor running time is conservative to ensure that each slit
fully opens.
When the open cycle is complete, the status will display Shutter is open.
Find Home