Goliath Solutions SPIDER-10-001 Benutzerhandbuch
FSM Cable Installation & MEU Activation
Page 7 of 43 Rev. 1A, Rev. Date: 8/31/2006
Use or Disclosure of this document is covered under the Non-Disclosure Agreement executed between the
prospective vendor and Goliath Solutions LLC.
Store Installation:
During the installation process make sure to document any issues that may occur during the
install and record them in QuickBase after the installation. (Do not forget to enter the MEU
information, the start time, and the end time of the install, and the MEU Mount into
QuickBase).
After completing the store check-in procedures you will conduct a store survey. The store
survey is separated into two parts. They are the MEU Survey and the Equipment Survey. The
purpose of the MEU survey is to determine the location of the MEU. The purpose of the
Equipment Survey is to determine the location of all the transmitters and receivers in the store
and stock room.
MEU Survey:
This is your top priority after checking into the store. You must determine the location for the
MEU to be installed in the store. The location of the MEU is critical to the success of the
install.
With the floor plan and pre-install survey walk through the store and determine the location of
the following:
1) The MEU location. (This may be marked by either 2 black push pins or 2 green dots that
MEU to be installed in the store. The location of the MEU is critical to the success of the
install.
With the floor plan and pre-install survey walk through the store and determine the location of
the following:
1) The MEU location. (This may be marked by either 2 black push pins or 2 green dots that
were placed in the early pre-installation surveys). You will be marking the location of all
MEUs and antennae with a mark placed on the floor. Use a wet erase marker found in the
tool kit to mark the floor with antenna locations the mark should be as follows R1 R2 R3
…….to the final receiver on the floor and T1, T2, T3 for the transmitter locations. This
mark should be on the floor directly below the spot of the antenna
MEUs and antennae with a mark placed on the floor. Use a wet erase marker found in the
tool kit to mark the floor with antenna locations the mark should be as follows R1 R2 R3
…….to the final receiver on the floor and T1, T2, T3 for the transmitter locations. This
mark should be on the floor directly below the spot of the antenna
2) The location of the LAN cabinet.
3) The location of the power by the front TV.
4) The location of the stock room.
5) The location of the furthest receivers (ARA) and transmitters (ATA) from the proposed
MEU location. You will be marking the location of all MEUs and antennae with a mark
placed on the floor. See note above in #1
placed on the floor. See note above in #1