KING 433RA Benutzerhandbuch
Page 4
DRAFT 05-20-10
SATELLITE ACQUISITION
1. Determine your elevation from the appropriate map in Section 4 ELEVATION MAPS, or by
entering your current location’s zip code in the satellite receiver prior to navigating to the
signal meter screen (see receiver’s owner’s manual).
signal meter screen (see receiver’s owner’s manual).
2. Follow the instructions in your receiver’s owner’s manual and navigate to the signal meter
screen. Select the appropriate transponder:
DISH Network
®
= 11 DIRECTV
®
= 19
2. Press and hold POWER until remote turns ON.
The remote will display the antenna’s current elevation.
3. Use the UP and DOWN arrows to
match the antenna’s elevation
(on the remote) to the elevation
you determined from the map
or your receiver.
(on the remote) to the elevation
you determined from the map
or your receiver.
4. Watch the signal meter screen on the TV. Use the LEFT and RIGHT
arrows to rotate the antenna and watch for signal strength to appear
on the screen.
on the screen.
IMPORTANT: STEP 4. You must watch the TV for signal strength while rotating the antenna in step 4.
See your receiver’s owner’s manual to determine how to display the signal meter screen on
your TV.
your TV.
When pressing the left and right arrows, the remote will continuously beep with a short pause
in between: beep - beep - beep...
in between: beep - beep - beep...
If the unit reaches its rotational limit in either direction, the remote will display REVERSE
DIRECTION and beep rapidly: beep beep beep... Press other arrow to reverse rotation.
DIRECTION and beep rapidly: beep beep beep... Press other arrow to reverse rotation.
IMPORTANT: For satellite acquisition, there must be a clear “line of sight” to the southern sky. Mountains,
buildings, trees, telephone poles, etc. can all block the satellite signal from reaching the dish.
Note: Pressing and releasing buttons on the remote control will produce an electronic click.
SECTION 2
OPERATION