Guangzhou Chiyuan Electronic Co. Ltd. N-4QA Benutzerhandbuch
R/C Introduction Manual
2
1.1 N-4Q Transmitter Chart
Steering Wheel
Throttle Trim
Steering Trim
Throttle Trigger
电池仓
Edit Buttons
AUX Channel
Steering
Dual Rate
Edit Buttons
EXIT
ENTER
MODE&DATA
EXIT
ENTER
Battery Box
MODE&DATA
+
MODE&DATA
–
Antenna
LCD
Throttle Hold
Power Switch
Charging Jack
R/C Introduction Manual
1
Caution
!
To work your R/C with your models correctly and safely, read this manual carefully and
keep it in a safe way as a reference introduction in the future.
keep it in a safe way as a reference introduction in the future.
!
Warning:
1. This product is only equipped for radio controlled models;
2. The usage of this product should be approved by local relevant law or regulations;
3. We will not be responsible for the damages caused by unauthorized modification,
1. This product is only equipped for radio controlled models;
2. The usage of this product should be approved by local relevant law or regulations;
3. We will not be responsible for the damages caused by unauthorized modification,
adjustment or replacement of parts of this product;
4. The manual may be altered without prior notice. Please contact us if you have any
4. The manual may be altered without prior notice. Please contact us if you have any
corrections or clarifications that should be made in the manual.
!
Please pay more attention to the parts in this manual, which are marked with “Warning”.
!
Because of disturbance, do not work your radio control system simultaneously with others
at the same frequency.
at the same frequency.
!
Before starting the transmitter, make sure the transmitter batteries are well loaded .The
voltage of transmitter batteries is never lower than 8.6V. And please check and confirm that
voltage of transmitter batteries is never lower than 8.6V. And please check and confirm that
the servos are all well and properly connected.
!
Please check and have a test on control surfaces to confirm the transmitter handling of each
part prior to each takeoff. The frequencies of the module and the receiver should be the
part prior to each takeoff. The frequencies of the module and the receiver should be the
same.
!
Keep the radio system away from moist, high temperature and strong shake. Do not clean
the product with solvent.
the product with solvent.
!
The antenna does not touch anything else when power switch is turned on. Do not leave this
product and its accessories within the reach of small children.
product and its accessories within the reach of small children.
!
Please use this product according to your local relevant law or regulation, we are not
responsible for any incidents or damages.
responsible for any incidents or damages.