Guangzhou Chiyuan Electronic Co. Ltd. N-4QA Benutzerhandbuch

1.2 2.4G BINDING

Function

The XY300 receiver must be bound to the transmitter before it will operate. Binding
is the process of teaching the receiver the specific code of the transmitter so it will
connect to that specific transmitter. Once bound, the receiver will only connect to the
transmitter when the previously bound model memory is selected. If another model
memory is selected, the receiver will not connect. This feature is called Model Match
and prevents flying a model using the wrong model memory.

FLASH

XY300

5. With the system hooked up as shown, insert the bind plug in the charge plug receptacle.

Turn on the power of the receiver (4.8~5.6v), and now LED(XY300) should be flashing

indicating that the receiver is ready to bind.

1.Use enter to the function menu and Press '+' or '-' to

find "MODULATE" in the menu (see the left chart), and

press "ENTER" to enter the interface. 2.4G binding can be

realized in this menu.

2.Press ' + ' or ' - ' to select "YES".

3.Press ' ENTER' to set the binding. Now ' SETTING'

appears in the menu, the transmitter is searching the

binding signal. (see the left chart)

6. LED(XY300) should be go solid, indicating the system has connected.

Now remove the bind plug and disconnect the battery.

LIGHT

Xy300

R/C Introduction Manual

4.When ' SET OK' appears in the menu, this indicates

that the binding has connected.(see the left chart)

Please note: this step does not mean the binding is

successful. Only the LED on the receiver goes solid, it

indicates that the binding is successful.

S E T I G ...